Sp And User Tool Settings Required For Installation - Ricoh D093 Service Manual

SP and User Tool Settings Required for Installation

This is a summary of the important SP and User Tool settings that are necessary for this
installation.
Main Machine Installation
2801-2 Lot Number 1
2801-3 Lot Number 2
2801-1 Initialize Developer
2923-1 Execute Cleaning Blade
Replace Mode
3001-2 Initialize ID Sensor
User Tool System Settings > Tray
Paper Setting > Next > Paper
Type: Tray n
User Tool System Settings > Timer
Settings > Set Date, Set
Time
SM
Enter the developer lot numbers at
installation before doing SP2801-1
Mixes developer and supplies toner.
Applies a thin layer of toner to the drum.
This prevents scratches on the drum when
the machine power comes on for the first
time.
Initializes the ID sensor after toner has
been applied to the drum.
Sets the paper type for each tray:
Tray 1: Roll 1
Tray 2: Roll 2
Tray 3: Cassette
Bypass
Check the date and time setting. If they
are not correct, set the correct date and
time.
3-5
Preparation
D093/D094