Attaching The Narrow Mylars To The Main Machine - Ricoh D093 Service Manual

Roll Feeder (D503/D504)
Open and close the paper exit cover C1 and paper exit unit C2 together to confirm
that the rear cover is installed correctly. If the paper exit cover does not open
properly, remove the rear cover and install it again.

Attaching the Narrow Mylars to the Main Machine

1. Use a clean cloth, moistened with a small amount of alcohol, to clean the area around the
rib .
2. Remove the tape from each end of one of the narrow mylars.
3. Attach one end to the top edge of the cover
The top edge must be flat and parallel to the edge of the cover. The right edge of
the mylar must be parallel to rib
4. Attach the other end of the mylar to the bottom edge of the cover
5. Do this procedure again to attach the other narrow mylar to the right side of the cover.
D093/D094
.
.
3-44
.
SM