Moving And Transporting The Machine - Ricoh RMY-P1 Field Service Manual

2. Installation

Moving and Transporting the Machine

• It is dangerous to handle the power cord plug with wet hands. Doing so could result in electric
shock.
• Unplug the power cord from the wall outlet before you move the machine. While moving the
machine, take care that the power cord is not damaged under the machine. Failing to take these
precautions could result in fire or electric shock.
• When disconnecting the power cord from the wall outlet, always pull the plug, not the cord. Pulling
the cord can damage the power cord. Use of damaged power cords could result in fire or electric
shock.
• The printer weighs approximately 12.7 kg (28 lb.). When moving the printer, use the inset grips on
both sides, and lift slowly in pairs. The printer will break or cause injury if dropped.
• When moving the printer after use, do not take out any of the toners, nor the waste toner bottle to
prevent toner spill inside the printer.
• Do not hold the control panel while moving the printer. Doing so may damage the control panel,
cause a malfunction, or result in injury.
• Be careful when moving the printer. Take the following precautions:
• Turn off the main power.
• Close all covers and trays, including the front cover and bypass tray.
• If optional paper feed units are attached, remove them from the printer and move them separately.
• Be sure to place the printer on a smooth and stable place.
• Keep the printer level and carry it carefully, taking care not to jolt or tip it. Rough handling may
cause a malfunction or damage the hard disk or memory, resulting in loss of stored files.
• Protect the printer from strong shocks. Impact can damage the hard disk and cause stored files to
be lost. As a precautionary measure, files should be copied to another computer.
16