Table of Contents
Advertisement
Step 3: Magnification for Paper Type: Translucent
1.
Make a 1:1 copy of the A0 SEF Magnification Chart with translucent (tracing) paper.
You can use a different test chart, if it has lines 1000 mm long in the sub-scan
direction and 700 mm long in the main-scan direction.
2.
Measure the length and width of the images on the original and the copy.
3.
Do the same measurements that you did for "Step 1: Magnification for Paper Type: Plain".
4.
Do these SPs in the sequence shown in this table, if the measurements are not in the
standard range:
SP
Standard
2916-3
Less than ±0.5
2916-4
Less than ±0.5
Step 4: Magnification for Paper Type: Film
1.
Make a 1:1 copy of the A0 SEF Magnification Chart with film.
You can use a different test chart if it has lines 1000 mm long in the sub-scan
direction and 700 mm long in the main-scan direction.
2.
Measure the length and width of the images on the original and the copy.
3.
Do the same measurements for "Magnification for Paper Type: Plain".
4.
Do these SPs in the sequence shown in this table, if the measurements are not in the
standard range:
SP
Standard
2916-5
Less than ±0.5
2916-6
Less than ±0.5
SM
Fine Magnification
Translucent: Mode 1-4: Main Scan
Translucent: Mode 1-4: Sub Scan
Fine Magnification
Film: Mode 1-4: Main Scan
Film: Mode 1-4: Sub Scan
5-105
Special Adjustments
D093/D094
Advertisement
Table of Contents
Troubleshooting
