Registration Buckle Adjustment – Cassette Feed; Fusing Temperature Adjustment - Ricoh D093 Service Manual

1003 Registration Buckle Adjustment – Cassette Feed
This SP eliminates the amount of buckle at the registration roller.
When paper is fed from the paper cassette, before the registration rollers
start to rotate the leading edge of the paper stops and hits the nip of the
registration rollers and stops.
The registration rollers remain idle long enough to stop the paper from
skewing in the paper path.
This SP adjusts the amount of time that the registration rollers remain idle to
reduce paper buckle.
Raise this setting to lengthen the amount of time that the paper pauses at the
nip of the registration rollers if you notice a large amount of skew in printouts.
[-20 to +20 / 5 / 1]
1105

Fusing Temperature Adjustment

Be sure to switch the main power switch off and on after adjustment.
1 Copy Ready Temperature
Sets the copy ready fusing temperature. The setting is the difference from the
target fusing temperature that is set with SP1931.
[0 to 50/10/1°C]
Copying can start at this temperature before the hot roller reaches its target
temperature (SP1931).
3 Low Power Mode
Sets the copy ready temperature for low power mode.
[80 to 150/90/1°C step]
SM 6-3
Main SP Modes
D093/D094