Table of Contents
Advertisement
3.
Loosen screws [A] and [B] and slide the plates to the rear.
4.
Remove the LPH [C].
Re-installation
1.
New silver ground wires are provided with the new LPH unit.
2.
After re-installing the LPH do SP2943, input the values that are printed on the label
attached to the replacement unit. (
3.
Do SP2952 and input the values that are printed on the label attached to the replacement
unit. (
p.5-116 "LPH Adjustment with SP Modes")
4.
Make a test print and adjust if necessary. (
SM
p.5-116 "LPH Adjustment with SP Modes")
p.5-116 "LPH Adjustment with SP Modes")
5-37
Around the Drum
D093/D094
Advertisement
Table of Contents
Troubleshooting
