Main Machine Final Installation; Set The Operation Panel Position; Select The Tray Paper Size And Type - Ricoh D093 Service Manual

Roll Feeder, Paper Cassette See Roll Feeder (D503/D504), Paper Cassette (B853).
Table. See Table (B854).
MFP Options. See Installation of MFP Options.
After installing all options, complete main machine installation. See Main Machine Final
Installation.

3.2.3 MAIN MACHINE FINAL INSTALLATION

Set the Operation Panel Position

You can adjust the position of the operation panel to reduce glare from overhead lighting hitting
the operation panel display.
1. Lift or lower the operation panel [1] to one set of the three sets of holes to set the panel at
the desired angle to reduce glare on the operation panel.
2. Push each anchor screw [2] into its hole (
It is not necessary to tighten the screws.
3. Attach the exposure glass cloth pocket [3].
4. Put the exposure glass cloth in the pocket [4].

Select the Tray Paper Size and Type

1. Push [User Tools] > "System Settings" > "Tray Paper Settings".
Selections are shown only for installed options. If you installed all the options, you
will see "Tray Paper Size: Tray 1" (1st Roll), "Tray Paper Size: Tray 2" (2nd Roll),
and "Tray Paper Size: Tray 3" (Cassette).
2. Select the paper size for each tray and bypass tray.
3. Select the paper type for each tray and bypass tray.
SM
Main Machine Installation (D093/D094)
x 3).
3-23 D093/D094