Lower Limit Temp: Press Roller - Ricoh D093 Service Manual

1936

Lower Limit Temp: Press Roller

This SP sets the minimum difference allowed between the actual temperature
and the target temperature of the pressure roller.
If the setting for the target temperature of the pressure roller is high
(SP1932), the temperature of the pressure roller is lowered for continuous
printing on plain paper.
At this time, if the temperature is below the temperature set for the
pressure roller, paper feed will stop during a long job to perform inching to
allow enough time for the pressure roller temperature to rise to the level of
the prescribed setting, and then the job will continue.
Important: Modes "1" to "5" below refer to the paper and thickness settings
selected in User Tools (see "Paper Thickness Default Selection" in this
section).
1 Plain: Mode1
2 Plain: Mode2
3 Plain: Mode3
4 Plain: Mode4
5 Plain: Mode5
6 Trans.: Mode1
7 Trans.: Mode2
8 Trans.: Mode3
9 Trans.: Mode4
10 Trans.: Mode5
11 Film: Mode1
12 Film: Mode2
SM
o
[0 to 50/0/5 C]
o
[0 to 50/20/5 C]
o
[0 to 50/0/5 C]
6-13
Main SP Modes
D093/D094