Press Fb Std Temp Coeff - Ricoh D093 Service Manual

SP1-xxx Feed
has started, the machine uses this setting to start the machine and ignores the
paper thickness mode settings.
When the prescribed time has elapsed after a cold start, temperature control
returns to the paper type and thickness settings.
However, this low temperature cold start does temperature control for plain
paper only, not for either translucent paper or film.
[60 to 80/120/5
1949

Press FB Std Temp Coeff

Press.Roller Ctr Temp. + (Press.Roller End Temp. - Press.Roller Ctr Temp.) x
SP1949-xxx = Press.Roller FB Temp.
The formula above uses the setting of this SP to determine the pressure roller
feedback temperature. The result of this calculation is used to calculate the hot
roller target temperature.
Note:
Settings can be selected below for the paper type, mode, and paper length.
Modes "1" to "5" below refer to the paper type and thickness settings
selected in User Tools (see "Paper Thickness Default Selection" in this
section).
11 Normal Mode1: > 611mm
12 Normal Mode1: 461-610mm
13 Normal Mode1: 298-460
14 Normal Mode1: < 297mm
21 Normal Mode2: > 611mm
22 Normal Mode2: 461-610mm
23 Normal Mode2: 298-460
24 Normal Mode2: < 297mm
31 Normal Mode3: > 611mm
32 Normal Mode3: 461-610mm
D093/D094
o
C]
2-36
[0 to 1/0/0.1]
SM Appendix