Cis Adjustment With Sp Modes; To Print The Cis Adjustment Pattern - Ricoh D093 Service Manual

Special Adjustments

5.12.2 CIS ADJUSTMENT WITH SP MODES

To Print the CIS Adjustment Pattern

1. Open the roll feeder drawer and cut off a sheet of paper from the widest roll. (Turn the
manual feed knob to feed the paper, then push the cutter from side to side to cut.)
2. Close the roll feeder drawer.
3. Enter the SP mode.
4. Open SP4417 Pattern 28, and touch [OK].
5. Touch "COPY Window" to go to the main screen.
6. On the operation panel, select one of the rolls for paper feed.
7. Put the blank sheet of paper on the original feed tray and feed it into the original feed unit.
Pattern 28 (grid pattern) prints.
8. Touch "SP Mode" to return to the SP mode.
9. Open SP4973, push [0] on the operation panel to change the setting from "2" to "0", then
push [#]
10. Touch "Exit" twice to leave the SP mode.
11. Select the paper roll size, then copy the grid pattern that you printed in Step 7 above.
When you look at the printed pattern, the number sequence of the CIS joints is
opposite, with CIS-5 on the left through CIS-1 on the right as shown in the diagram
above.
After completing the CIS adjustments, be sure to reset SP4973 to "2".
D093/D094 5-112 SM