Table of Contents
Advertisement
Main Machine Installation (D093/D094)
Enter Developer Lot Numbers
1.
Go into the SP mode.
2.
Do SP2801-2 and 3 to enter the lot numbers.
Use the soft keyboard on the display panel to enter the lot numbers. (The lot
numbers are embossed on the top edge of each developer pack.) If the numbers
are the same, enter the same number twice.
You must enter the lot numbers with SP2801-2 and -3 before doing SP2801-1. The
main machine will return an error ("Failed") if you attempt to do SP2801-1 before
SP2801-2 and -3.
Mix Developer, Supply Toner
1.
First, make sure that the toner cartridge has been installed in the machine. (See previous
section.)
2.
Next, do SP2801-1 to mix the developer and supply toner. This takes about 5 minutes.
3.
Do SP2923. This applies a thin layer of toner to the bare drum.
4.
Open the upper unit.
5.
Push the cleaning-blade release lever [1] to the right.
The cleaning-blade release lever keeps the cleaning blade away from the drum
during transportation. To prevent damage to the drum, before you move the main
machine to a different location, be sure to push this lever to the left.
6.
Close the upper unit.
7.
Do SP3001-2 to initialize the ID sensor. Initialization takes about 15 sec.
8.
Exit the SP mode and turn off the main power switch.
9.
If you will install one or more of the following options, do these installations at this time:
D093/D094
3-22
SM
Advertisement
Table of Contents
Troubleshooting
