Sc800; Energy Save I/O Subsystem Error - Ricoh D093 Service Manual

Service Call Tables

7.3.8 SC800

816 D

Energy save I/O subsystem error

An error was detected in the signal from the ASIC (controller board) which
controls the STR (Suspend to RAM) function.
Note: STR is a feature of this machine that minimizes energy consumption
while the machine is in the energy saver mode.
SC816-5
SC816-39
SC816-50
SC816-67
SC816-79
SC816-90
D093/D094
Reboot the machine.
Replace the controller board.
SCS
Machine attempted to enter STR mode before engine
was OFF.
Sub System
Error occurred during system start up.
Hardware
Printer version only. Not used for this machine.
NCS (Network Control Service)
An error occurred in the access control port list:
Number of registrations exceeded 125
Data notifications exceeded 12
Data extension incorrect
Sub System
Message mismatch.
Hardware/System
A forced system reset (WDOG) occurred.
7-32
CTL
SM