Cis Re-Installation - Ricoh D093 Service Manual

Scanner
Re-installation
1. Attach the three brackets removed from the old CIS unit to
the new CIS unit.
2. Install the new CIS in the machine.
3. Remove the SD card slot cover (x1).
⇒
4. Remove the SD card from Slot 1.
5. Insert the SD card (provided with CIS unit) in Slot 1.
6. Re-connect the machine power plug and switch the
machine on.
7. Wait for the "Ready" screen to display.
⇒
SC870 will be displayed at this time, triggered by the removal of the SD card in
Step 4 above. However, this is not because of a problem with the machine or SD
card, so continue on with this procedure. The SC will be cleared after you reinsert
the SD card and turn the machine power ON again in Step 13.
8. Press the [Program] key on the right side
of the operation panel.
9. On the operation panel, press [0]> [1]>
[Start].
10. Press the [Program] key then touch [Exit] to return to standby mode.
11. Press the operation power switch to switch the machine off, then switch off the main power
switch.
⇒
12. Remove the SD card from Slot 1.
⇒
13. Reinsert the SD card that you removed in Step 4 back into Slot 1.
⇒
14. Reattach the SD card slot cover, and then turn ON the machine main power.
: When the machine boots up, SC870 will no longer be displayed.
15. Remove the SD card from Slot 1, replace the SD card slot cover, then turn the machine on.
16. Do SP4417 and print Pattern 28 to check the CIS.
17. Do a test copy and check the quality.
After replacing the CIS, store the SD card and the data sheet with the flat brush
stored on the right bottom edge of the main machine.
D093/D094 5-22
Rev. 02/21/2011
SM