Toshiba T3200 User Manual page 108

4.5 REMOVING/REPLACING THE INDICATOR PCB, THE CABLE GUIDE AND
THE PLASMA PCB
1. Confirm that the POWER switch is off and unplug the ac cord.
2. Remove the PDP as directed in part 4.4.
3. Pull the ground cable (A) from the PDP cover assembly (B).
4. Lift the indicator PCB (C), then disconnect an indicator
cable (D) from the indicator PCB.
4. Take off the indicator cable, ground cable, plasma display
power cable (E) and plasma display signal cable (F) from the
cable guide (G), then remove the cable guide.
5. To remove the volume PCB (H), remove the single screw (I)
from the PDP cover assembly.
(8)
-I.-J'--II'f---
(H)
(G)
(F)
- - - , t . , . ,
FIGURE 4-6 Removing the Indicator PCB and the Cable Guide
4-7