Toshiba T3200 User Manual page 116

4.11 REMOVING/REPLACING THE BOD
CAUTION: The hard disk contents will remain in the old hard
disk. If desired, transfer the contents of the old hard
disk onto a floppy disk before replacing the hard disk.
This can be done with the MS-DOS BACKUP command. (See
the MS-DOS manual for details.)
1. Confirm that the POWER switch is off and unplug the ac cord.
2. Remove the top cover and FDD base as directed in part 4.2
and 4.10.
3. Disconnect the HOD power cable (A) and HOC cable (B) from
the HOD (C).
4. To remove the HOD, hold the HOD and remove the four screws
(D) from the bottom of the base assembly (E).
(E)
FIGURE 4-15 Removing the HOD
5. To install a new HOD, follow the above procedures in
reverse.
(8)
6. Enter the MS-DOS FDISK command, which will set the
partition. Then enter the MS-DOS FORMAT command. (See the
MS-DOS manual for details.)
4-15