Toshiba T3200 User Manual page 102

4.1 GENERAL
This section gives a detailed description of the procedures used
to replace FRUs (field replaceable units).
FRUs consist of the following:
1. Top Cover
2. PDP (Plasma Display Panel) Mask
3. PDP
4. Indicator PCB
5. Cable Guide
6. PDP Cover Assembly
7. Keyboard Unit
8. Speaker
9. Lithium Battery
10. Power Supply Unit
11. FDD (Floppy Disk Drive)
12. HDD (Hard Disk Drive)
13. Expansion Bus PCB
14. Fan
15. HDC (Hard Disk Control PCB)
16. Syatem PCB
The following points must be kept in mind:
1. The system should never be disassembled unless there is a
problem (abnormal operation, etc.)
2. Only approved tools may be used.
3. After deciding the purpose of replacing the unit, and the
procedures required, do not carry out any other
procedures which are not absolutely necessary.
4. Be sure to turn the POWER switch off before beginning.
5. Be sure to disconnect the ac cord and all external cables
from the system.
6. Follow only the fixed, standard procedures.
7. After replacing a unit, confirm that the system is
operating normally.
Tools needed for unit replacement:
1. Phillips Screwdriver
2. Bladehead Screwdriver
3. Tweezers
4-1