Toshiba T3200 User Manual page 83

3.16.2 Operations
CAUTION: After physical formatting is finished, enter the MS-DOS
FDISK command, which will set the partition. Then enter
the MS-DOS FORMAT command. (See the MS-DOS manual for
details.)
1. After pressing 2 and Enter to select from the DIAGNOSTICS
MENU, the following display will appear.
DIAGNOSTIC - HARD DISK FORMAT: VI.O
I - All track FORMAT
2 Good track FORMAT
3 Bad track FORMAT
4 Bad track CHECK
9 Exit to DIAGNOSTICS MENU
Press [NUMBER] key?
2. All track FORMAT Selection
(1) When All track FORMAT (1) is selected, the following
message will appear.
Interleave number (3/1-9) ?
(2) Select an interleave number. (Usually select 3.) Type the
number and press Enter. The following message will
appear.
Drive number select (1:11. 2:12)
?
(3) Select a drive number. Type the drive number and press
Enter. The following display will appear.
[HOD TYPE]
[HOD TYPE]
[HOD TYPE]
CYLINDER
HEAD
SECTOR
=
XXX
=
X
=
XX
[WARNING: Current DISK data will be
completely destroyed]
[[cylinder,head
=
XXX X]]
3-28