Toshiba T3200 User Manual page 24

PROCEDURE 2
Beep Sound Check
1. Turn the POWER switch off.
2. Turn the POWER switch on.
3. If the system occurs an error, the system informs you of an
error code with the beep sound. (That is the bit information
of DL register.)
The system repeats the buzzer message three times. A
hexadecimal number is configured by the combination of two
groups of the beep sounds, each of which is composed of
either short sounds or long sounds.
The status of an error code is as following table.
4. If the error code conforms to the values given in the table,
go to PROCEDURE 5.
5. If the error code doesn't conform to the values given in the
table, another FRU is probably defective.
OH
lH
2H
3H
4H
5H
6H
7H
BH
9H
AH
BH
CH
DH
EH
FH
TABLE 2-4 Beep Sound Error Code
2-12