Toshiba T3200 User Manual page 75

Subtest 05 300/1200 BPS card modem loopback (Execution time: 5
seconds)
Note: If there is no modem card in the system, this test
can not be executed.
This test is used to check whether the data, which
is from the modem to the RS232C inside the system,
is same as the original data which had first been
sent to the modem card.
Subtest 06 Card modem on-line test (Execution time: 10 seconds)
Note: After the system is connected to the PBX, unless the
receive side is in the same status as the send side,
the test cannot be executed.
In this test, first some data are sent to the modem
card from the RS232C inside the system, then the
data is again sent to the other system through the
PBX (Private Branch Exchange).
This test is used whether the returned data from the
other system are same as the original data.
Subtest 07 Dial tester test (Execution time: 60 seconds)
Note: To execute this test, a dial tester must be
connected to the system.
This test is carried out by sending the pulse dial
and tone dial twice automatically.
[Pulse dial]: "1-2-3-4-5-6-7-8-9-0-1-2"
[Tone dial]: "1-2-3-4-5-6-7-8-9-*-0-#"
3-20