Toshiba T3200 User Manual page 32

PROCEDURE 2
Messaqe Check
1. When the diagnostics disk is inserted into the FDD and the
POWER switch is turned on, message (a), message (b), message
(c)
or message (d) should appear.
(a) (**** FDD A in not installed ****
(b)
Non-System disk or disk error
Replace and press any key when ready
**
FDD load error or Bad system disk
**
(c) Insert system disk in drive
Press any key when ready •.•••
**
HOD Load error or Bad system disk
**
(d)
Insert system disk in drive
Press any key when ready •••••
)
2. If (a) of the above message is displayed, confirm that the
A-B-PRT switch is set to the PRT side. If it is not seted to
the PRT side, set the PRT side; if it is seted to the PRT
side, go to PROCEDURE 5.
3. If (b),
(c)
or (d) of the above messages is displayed, the
contents of the floppy disk are damaged, or some other disk
than the diagnostics disk has been inserted into the FDD.
Change the diagnostics disk. If loading then occurs, go to
PROCEDURE 4; if loading does not occur, go to PROCEDURE 3.
4. If none of the above messages appears, go to PROCEDURE 5.
2-20