Toshiba T3200 User Manual page 117

4.12 RBMOVING/RBPLACING THE EXPANSION BUS PCB AND THE FAN
1. Confirm that the POWER switch is off and unplug the ac cord.
2. Remove the top cover and the FDD base as directed in part
4.2 and 4.10.
3. Disconnect the fan and HOD power cable (A) from the HOD (B)
and the system PCB (C).
4. Remove the two screws (D), then lift it up.
5. To remove the fan on the expansion bus PCB (E), remove the
two screws (F).
(C)
(8)
FIGURE 4-16 Removing the Expansion Bus PCB and the Fan
6. To install a new expansion bus PCB and a new fan, follow the
above procedures in reverse.
4-16