Toshiba T3200 User Manual page 23

PROCEDURE 1
Message Check
1. Turn the POWER switch on.
2. If the system is loaded, go to PROCEDURE 3.
3. If the following message is displayed on the screen, press
the Fl key. Execute the setup. (Refer to OWNER'S MANUAL in
PART 6.)
*** Error in CMOS. Bad battery ***
Check system Then. press [Fl]
key ......
*** Error in CMOS. Bad check sum ***
Check system Then. press [Fl] key .•••.•
** Error in CMOS. Bad configuration **
Check system Then. press [Fl]
key ..•.•
a
*** Error in CMOS. Bad memory size ***
Check system Then. press [Fl]
key .•••••
** Error in CMOS. Bad time function **
Check system Then. press [Fl]
key ......
4. If the following message is displayed on the screen, go to
HOD isolation procedures in part 2.6.
** HOD Load error or Bad system disk **
Insert system disk in drive
Press any key when ready ..•..
5. If none of the messages are displayed and you have a printer
port LED, go to PROCEDURE 3.
If none the messages are displayed and you don't have a
printer port LED, go to PROCEDURE 2.
2-11