4.13 REMOVING/REPLACING THE BARD DISK CONTROL PCB
1.
Confirm that the POWER switch is off and unplug the ac cord.
2.
Remove the expansion bus PCB as directed in part 4.12.
3.
Disconnect the HDC cable (A) from the HDD (B), then remove
the two screws (C) from the HDC (D).
4.
To remove the HDC from the system PCB (E) lift it up.
(C)
(8) -
_ _ _ -.::.
(E)
FIGURE 4-17 Removing the HDC
5.
To install a new HDC, follow the above procedures in
reverse.
4-17