Amano Time Guardian Series Installation And User Manual page 78

To configure for an HP 1000, 2000, 3000, or 4000 Terminal set the following:
Reject Threshold: The sensitivity of the terminal to the user's hand geometry. Permitted values
are 40 [strictest setting] through 200 [least strict setting-almost off], with a default of 125.
Lock Control: The duration, in seconds, that the Lock Control output of the terminal will be
activated. The default is 10 seconds
ID Length: The User ID number length. Permitted values are 1 through 11, with the default
being 11. 10 digits are the maximum in any case, but if 11 are specified, the Enter key (#) must
be pressed after the 10th digit is entered.
Access Tries: The number of hand reading attempts a user is permitted to try hand readings
before being refused. The default is 6.
Passwords: The following fields are used to assign the Command Mode Group passwords for
the selected terminal. Each password may be up to 10 digits long
a. Security: Disable the hand reading checks in the terminal [required field].
b. Enrollment: Enroll and remove users [required field].
c. Management: General system management operations [required field].
d. Setup: Set the baud rate and number of the terminal [required field].
e. Service: Access to service and diagnostic functions [required field].
Punch Mode: Select one or both of the following data entry modes:
a. Explicit Punch: If checked, the Explicit Punch Menu will be enabled at the terminal.
b. Department Code: If checked, a Department Code will be requested each time a user
punches; otherwise the user must press the # key once before entering their ID number to
display the Department Code prompt.
23. To update the terminal settings, click on the Update button. This will download the current
settings in this window to the terminal.
24. After completing the entry/selection of information for
Next button to advance to
3-54
Step 9: Login Setup.
Step 8: Terminal Setup, click on the
Time Guardian Series
– Setup Wizard