Do You Want To Configure Your Terminals? - Amano Time Guardian Series Installation And User Manual

Special Note: Selecting Holidays will only work with HandPunches (all HandPunch models).
A Bell schedule requires you to enter the Duration for the bell to ring, the time of day for the bell
to ring and the days of the week. Multiple entries can be made for Bell Schedules with different
duration and day assignments. Bell Schedules are downloaded to the selected terminals by
location in the Communications
1. Create a new Bell Schedule and you will be required to enter a name for the Bell Schedule
[yellow required field].
2. In the Description field, enter in a brief description of the Bell Schedule.
3. Click on the Add button. A blank row will appear in the Bells grid.
4. Enter a time (in 24 hour format) of the day in the Time column that the desired bell signal will
be activated.
5. Enter the duration (in seconds) in the Duration column that the bell circuit will be activated
for.
6. Check the appropriate day(s) of the week and/or Holiday (Holidays only work with
HandPunch terminals) that the bell circuit will be activated.

Do you want to configure your terminals?

If Yes is selected, click the
Locations screen will appear (see figure). Answer Yes to this question if you are using
terminals such as a Hand Punch, FPT-40 (Fingerprint), and/or MTX-15 terminal via a serial,
Ethernet, or modem connection.
– Setup Wizard
Time Guardian Series
module. To do so, perform the following:
Location/Terminal button and the
3-49