Nexus 220 Integration; Wizard Setup For Nexus 220; Employees Setup For Nexus 220; For Nexus 220 Access Control Use - Amano Time Guardian Series Installation And User Manual

Using Access Control Module

Nexus 220 Integration

Wizard Setup for Nexus 220

The following paragraphs detail the steps involved in setting up the Nexus 220 Access Control
System during Employee Setup with the Setup Wizard (see Step 7: Employee Setup Wizard for
additional Wizard information).
Employees Setup for Nexus220
The Access Control Module must be activated for the Nexus 220 tab not to be grayed out. Once
this module is activated, Nexus 220 tab will be active during employees Step 7 Wizard Setup if
you selected to integrate the Nexus 220 for Access Control from the General tab of the Setup
Wizard. When Nexus 220 Access Control software is connected to an AC or EC controller 4
tags are available (see the following figure for an example with 4 Tags). Tag1 can be used to
assign access levels, sites, and tag options to the badge or tag number entered in the General
tab. Tag2, thru Tag4 can be used to add and configure additional tag(s) or badge(s) for the
employee to use. Click on the Nexus 220 tab and the following type of screen will appear:

For Nexus 220 Access Control use:

Enter PIN: The 5-digit number that an employee may have to enter at an access control device.
Click on Tag 1 through Tag 4 and the following type of screen will appear:
Note: For Tag 1 the Badge number (Tag Code) is disabled as it is Read only, but it is enabled
in the other tags. It will be Read only and the same as the Badge number.
16-2 – Access Control Module
Time Guardian Series