Terminal Setup Nlm - Amano Time Guardian Series Installation And User Manual

If you wish to assign another tag for the employee, click on the Tag 2, thru Tag 3 buttons and
follow a similar procedure performed for Tag 1.
After completing the entry/selection of information for
Next button to continue to
Step 3: Terminal Setup NLM [Optional]
Note: Prior to commencing this step, it is recommended you install your Nexus Lite access
controller terminal, using the appropriate Nexus Lite installation guide. The Nexus Lite is
installed to communicate with the host PC. The appropriate documentation will provide
the necessary steps to install the Nexus Lite controller(s) and reader(s). You may need
to obtain the IP address for each Ethernet Nexus Lite connected to the system.
Step 3: Terminal Setup
•
The company wants to use Nexus Lite(s) for access control.
Do you want to configure Terminal Validation?
If Yes is selected for Terminal Validation, click the
Validation screen will appear (see figure). Terminal validation provides employee filtering from
the setup configured in the General and Employee tabs (see the figures).
Terminal Validation is used to assign employees to selected terminals (Nexus Lite's). When
validation is used, only employees assigned to a particular terminal can use the terminal.
Validations are downloaded to the selected terminals by location in the Communications
module. To create validation, perform the following:
23-16
Step 3: Terminal
is optional; use this step only if:
Step 2: Employee
Setup.
Terminal Validation
Time Guardian Series
Setup, click on the
button and the Terminal
– Nexus Lite Module