Location Of Synthetic-Resin Parts - Mitsubishi Electric Lancer Evolution-VII Workshop Manual

SYNTHETIC-RESIN PARTS -
No. Part number
1 Outside mirror
2 Rear spoiler
3 Roof antenna
4 Headlamp
5 Front bumper bezel
6 Rear door outside handle
7 Front door outside handle
8 Splash shield
9 Oil cooler duct
10 Instrument panel
11 Front pillar trim
12 Inside rear view mirror
13 Centre pillar trim
14 Rear pillar trim
15 Rear door trim
16 Rear end trim
17 Rear scuff plate
18 Rear console box
19 Front scuff plate
20 Cowl side trim
21 Front bumper extension
22 Front bumper face
23 License plate garnish
24 Front door trim
25 Rear bumper face
26 Side sill extension
27 Center pillar trim lower
28 Front deck garnish
29 Floor console
30 Hood inlet upper garnish
31 Roof drip molding
NOTE
1. If the new material symbols designated by the ISO differ from the old symbols, both are given, with
the old symbols enclosed in brackets.
ISO: (International Standardization Organization)
2. A slash (/) in the material symbol indicates that two different materials compose a 2-layer construction.
A plus sign (+) indicates that the two different materials are mixed.
3. The material symbols for synthetic-resin parts are embossed on parts in hidden places.

Location of Synthetic-resin Parts

Material
Acrylonitrile
Butadiene styrene
Acrylonitrile
Ethylene butadiene
Polycarbonate
Polycarbonate +
Acrylonitrile butadiene styrene
Polyethylene
Polypropylene
Rubber denatured polypropylene
With talc added rubber denatured
polypropylene
With 20% talc added rubber dena-
tured polypropylene
With 10 % talc added polypropylene
With 20 % talc added polypropylene
Polyphenylene ether + Polyamide
Polyvinyl chloride
Abbreviation of Heat-resistant
material temperature (_C)
ABS 80
AES 90
PC 120
PC + ABS 125 - 135
PE 100
PP 80
PP + E/P 80
PP + E/P- TD 80 - 100
(HMPP)
PP + E/P- TD20 110
(HMPP)
PP - TD10 110 - 120
(PPF)
PP - TD20 120 - 130
(PPF)
PPE+PA 185
(PA/PPO)
PVC 80
E-3