Type Id; Partial Point Programming Flow Chart - Notifier AM2020 User Manual

1=TYPID
Option 1 of the Partial Point Programming Menu allows the programmer to change the Software Type ID of
any detector, module, zone or annunciator point. This pre-setting of all devices in the system gives the control
panel the ability to execute specific functions for each device type. The following CRT display illustrates the
assignment of the Software Type ID SCON to the 14th monitor module on SLC Loop 3.
PRESS@1=TYPID,2=CBE,3=LBL,4=OPTNS,5=AMAP,6=CCBE@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@:@1
ENTER@LXX(D/
M)YY,@ZXXX@OR@AXXPYY@FOR@PT.@CHANGE@(BCKSPC@TO@ABORT)@@@@@@@:@L3M14
ENTER@TYPE@ID@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@:@SCON@
For a complete description of the various Software Type IDs, see Software Type IDs .
Programming 15088:J 10/22/99
www.PDF-Zoo.com
3 = PPRG
Select Partial Point
Programming Submenu
Option 1-6
(Change device, zone, or annunciator
point software type ID)
(change CBE list or equation which
controls interaction between devices,
and software zones)
(change custom label associated with
each device, and software zone)
4 = OPTNS
(enable/disable for each device signal
silence, walk test, alarm verification,
sensitivity, or tracking)
(individually maps devices or software
zones to annunciator points for remote
annunciation)
(change CCBE equation associated
with reverse activated zones)

1 = TYPID
see Section 1.3.1
2 = CBE
see Section 1.3.2
3 = LBL
see Section 1.3.3
see Figure 1-11
5 = AMAP
see Figure 1-12
6 = CCBE
see Section 1.3.6
D }X3X1X
3-31