Main Programming - Notifier AM2020 User Manual

The Programming Mode is accessed by entering the following (level 2 password required):
After entering the Programming Mode, the display will show the Main Programming menu:
PRESS@1=PSYS,2=FSYS,3=PPRG,4=FPRG,5=REMV,6=PSWD,7=MSG,8=HIS@@@@@@@@@@@@@@@@@@:
The Main Programming menu has eight options, where:
1=PSYS
2=FSYS
3=PPRG
4=FPRG
5=REMV
6=PSWD
7=MSG
The Main Programming Menu flow chart is located in Figure 1-1. Detailed information on the Main Programming
options follows.
Programming 15088:J 10/22/99
www.PDF-Zoo.com
D } X
Partial System Programming - Selective programming of system-wide functions
(number of LIBs, AVPS-24/AVPS-24E*, ISIB, Signal-Silence Inhibit and Cut-out, Alarm
Verification, number of annunciator modules, etc.).
Full System Programming - Complete programming of system-wide functions (num-
ber of LIBs, AVPS-24/AVPS-24E*, ISIB, Signal-Silence Inhibit and Cutout, Alarm Verifi-
cation, number of annunciator modules, etc.).
Partial Point Programming - Selectively altering the operating parameters of LIB
SLC Loop devices, software-defined zones and annunciator points.
Full Point Programming - Complete programming of addressable LIB SLC Loop de-
vices, software-defined zones, annunciator points and their respective operating pa-
rameters.
Remove - Permits the selective removal (from control panel memory) of any of the
system's addressable SLC Loop devices, software-defined zones or annunciator
points.
Password - Allows the programmer to assign custom five-digit Level One and Level
Two passwords.
Message - Allows the Level Two programmer to define the custom 40-Character User
Label displayed on the CRT Monitor and the panel's Liquid Crystal Display (LCD).
8=HIS History - Allows the programmer to enable or disable storage of events and the clear-
ing of stored events.
* The number of APS-6R power supplies should be included in the AVPS count.
3-7