Notifier AM2020 User Manual page 223

The following system requirements are illustrated in Figure 1.3-3. See Table 1.1-1 in the introduction to this
section for monitor module options.
• One AM2020/AFP1010 Control Panel
• Multiple Security Supervisory Protected Areas
• Multiple Protected Premises
• One Monitor Module per protected area, Security Devices (minimum security equipment).
AREA 2
Programming Key for Figure 1.3-3
MM Security Area Monitor:
Address:
Type ID:
Control-By-Event: ( )
Custom Label:
Tracking:
Annunciator:
Annunciator Point
Mapping (Optional): AxxPyy
Security 15088:J 10/22/99
www.PDF-Zoo.com
TENANT A
AREA 3
2
AREA 1
(Perimeter)
2
AREA 1
(Perimeter)
TENANT B
Figure 1.3-3 Multiple Tenant Simple Security System
LXXMYY (Installer specified).
SARM
Installer Specified (describe location of module).
Yes - Results in required acknowledgment at Central Station for every unsecured state.
Restoral is automatic.
No - Results in required acknowledgment at Central Station for first unsecured state only (until
reset at Central Station - short condition only).
No (not required).
Yes (if annunciator mapping desired)
Motion Detector
Contact Switch
3
MM Security Area Monitor
1
Shaded Area Indicates Second Tenant
Smoke Detector
Signaling Line Circuit
3
1
Key
Pull Station
AM2020/AFP1010
Central Station
4-9