Full Point Programming; Full Point Programming Flow Chart - Notifier AM2020 User Manual

4=FPRG
Option 4 from the Programming Menu allows the programmer to completely program of all the addressable
detectors, modules, software-defined zones and annunciator points in the AM2020/AFP1010 system. The
programming examples illustrate the CRT screen prompts displayed during Full Point Programming.
For a description of each of the parameters programmed here, refer to Partial Point Programming.
The control panel continuously loops back through the Full Point Programming routine, allowing the
programmer to enter devices, software zones or annunciator points one after the other. Use the
Addressable
Detector
Enter Software
Type ID
Enter CBE List
Enter Custom
Label
Enable/Disable
Detector
Verification
Enter Detector
Sensitivity
(low, med, or high)
Enable/Disable
Tracking
Enable/Disable Day/
Night Sensitivity
Control
Map to
Annunciator
Point?
Yes
Enter
Annunciator
Point
3-36
www.PDF-Zoo.com
Backspace key to exit Full Point Programming.
Enter Software Zone, Addressable
Device, or Annunciator Point
(Backspace to Exit Mode)
Control Module
Enter Software
Type ID
Enter CBE
Equation
Enter Custom
Label
Enable/Disable
Signal Silence
Enable/Disable
Walk Test
Map to
Annunciator
No
Point?
Yes
Enter Annunciator
Point
No
D }X4X
NOTE
4 = FPRG
(panel determines item entered and branches accordingly)
Software Zone Annunciator Point
Enter Software Enter Software
Type ID Type ID
Enter CBE
*
Equation/List
**
Enter CCBE
(Reverse Zones
Only)
Enter Custom
Label
Map to
Annunciator
Point?
No
Yes
Enter
Annunciator
Point
Monitor Module
Enter Software
Type ID
Enter CBE List
Enter Custom
Label
Enable/Disable
Tracking Option
Map to
Annunciator
No
Point?
Yes
Enter
Annunciator
Point
*
Equation for Reverse Zone,
List for Forward Zone
** NOTI•FIRE•NET only
Programming 15088:J 10/22/99