Multiple Tenant Simple Security System; Central Station - Notifier AM2020 User Manual

The following system requirements are illustrated in Figure 1.3-2. See Table 1.1-1 in the introduction to this section for
monitor module options.
• One AM2020/AFP1010 Control Panel
• Multiple Security Supervisory Protected Areas
• One Protected Premises
• One Monitor Module per protected area, Security Devices
(minimum security equipment).
AREA 2
Programming Key for Figure 1.3-2
MM Security Area Monitor:
Address:
Type ID:
Control-By-Event: ( )
Custom Label:
Tracking:
Annunciator:
Annunciator Point
Mapping (Optional): AxxPyy
4-8
www.PDF-Zoo.com
TENANT A
AREA 3
3
2
AREA 1
1
(Perimeter)
Figure 1.3-2 Multiple Tenant Simple Security System
LXXMYY (Installer specified).
SARM
Installer Specified (describe location of module).
Yes - Results in required acknowledgment at Central Station for every unsecured state.
Restoral is automatic.
No - Results in required acknowledgment at Central Station for first unsecured state only (until
reset at Central Station - short condition only).
No (not required).
Yes (if annunciator mapping desired)
Motion Detector
Contact Switch
MM Security Area Monitor
Pull Station
Smoke Detector
Signaling Line Circuit
Key
AM2020/AFP1010

Central Station

Security 15088:J 10/22/99