Intelligent Serial Interface Board Programming - Notifier AM2020 User Manual

8=ISIB
Option 8 from the Partial System Programming Menu allows the programmer to change parameters associated with an
Intelligent Serial Interface Board (ISIB). ISIB Programming has four submenu options, ISIB Installation, Annunciator
Installation, External Interface Parameters and UDACT Selection. Detailed descriptions of the four ISIB programming
options are located on the pages that follow. The SIB-2048A and SIB-NET ISIBs are available for use with the AM2020/
AFP1010. For AM2020/AFP1010 with NOTI•FIRE•NET™ the SIB-NET is the only ISIB available. Refer to
Chapter One, Serial Communications , for a description of available intelligent serial interface boards.
8 = ISIB
Select ISIB
Submenu Option 1-4
3-22
www.PDF-Zoo.com
Change
1 = INSTL
ISIB?
(Sib installation)
2 = ANN
Enter annunciator
(annunciator to be changed
installation) (1-32)
Install
annunciator
selected?
Change
3 = XINT
Upload/
(external
Download?
interface)
Yes
Enable/Disable
Upload/Download?
Change
Channel No
No
A Threshold? B Threshold?
Yes
Enter Channel
Enter Channel
B Threshold
A Threshold
Change
4 = DACT
UDACT
(communicator
programming?
transmitter)
No
D }X1X8X
Yes Enable/Disable
ISIB
No
Yes
Enter Change
Yes
Label Another?
No
Change
No
Address?
Enter SIB Address
Change
Change MIB
Channel No
Data Port
Monitoring?
Yes Yes
Enter Number of
Channels to
Monitor
Yes
Install UDACT?
Yes
Enter base
address (1-32)
No
SIB
Yes
Change
No
No
ACK/SIL/RES?
Yes
Do you want
ACK/SIL/RES
No
disabled at panel?
Do you want
ACK/SIL/RES re-
No
enabled on LAN
Comm Fault?
No
Programming 15088:J 10/22/99
(Exit Program
Mode)