Programming From Multiline Terminal - NEC Electra Elite 48/192 Features And Specifications Manual

Programming from
Multiline Terminal
FEATURE
DESCRIPTION
SYSTEM
AVAILABILITY
OPERATING
PROCEDURES
SERVICE
CONDITIONS
Features and Specifications Manual
System Programming can be performed from designated Display Multiline
Terminals in the first two ESI(8)-U10 ETU ports. Some programming changes
become effective immediately. Other programming changes become effective
after applicable busy telephones and circuits become idle.
Terminal Type:
Display Multiline Terminals
Required Components:
ESI(8)-U10 ETU
Refer to the Electra Elite 48/192 Programming Manual for
additional information.
Data Assignment:
Use Memory Block 7-1 (Card Interface Slot Assignment) to specify the
¥
ESI(8)-U10 ETU.
Restrictions:
PC Programming and programming from a Multiline Terminal cannot be
¥
performed at the same time.
General:
The first two Multiline Terminal ports are programming positions (default:
¥
Stations 100 and 101).
Both stations can go off-line at the same time to program the system.
¥
P-10
P - 23