NEC Electra Elite 48/192 Features And Specifications Manual page 173

Issue 6
SERVICE
CONDITIONS
C - 54
To retrieve a parked call at either a Multiline Terminal or a Single
Line Telephone:
1. Go off-hook, and wait for internal dial tone.
2. Dial the Call Park Retrieve Access Code
default).
3. Dial the Call Park location number (
retrieved.
4. Talk with party.
Data Assignment:
Use Memory Blocks 1-1-46~48 [Access Code (1-, 2-, or 3-Digit)
¥
Assignment] to assign Access Code (4# for Call Park System Answer
or 4* for Call park System Transfer).
Use Memory Block 1-2-23 (System Call Park Recall Time Selection),
¥
to specify the time (default: 1 minute) before a parked call recalls
back to a station.
General:
Any call left in Call Park more than the programmed time recalls to
¥
the station where the call was originally parked. The Call Park
location becomes idle after the recall, and the trunk line key switches
to Non-Exclusive Hold.
When attempting to set Call Park to a busy Call Park location, and a
¥
busy tone is heard, Step Call can be used to access an idle location
to park the call.
When a station other than the station originally used to park the call
¥
retrieves the call, the SMDR records a transfer to the station where
the call is retrieved.
When a Call Park is in recall mode, the call cannot be picked up
¥
using the Call Park retrieval Access Code.
Call Park is set and retrieved from internal dial tone.
¥
Outside calls and internal calls can be parked from any station.
¥
Conference calls cannot be parked.
¥
When attempting to set Call Park and all Call Park locations are busy,
¥
a busy tone is heard and ALL PARK BUSY is displayed on Display
Multiline Terminals.
Electra Elite
D L
(set as
K I
~ ) of the call to be
Call Park - System