NEC Electra Elite 48/192 Features And Specifications Manual page 293

Issue 6
OPERATING
PROCEDURES
D - 84
All Operating Procedures assume these features are assigned to the
DTP-16HC-1 terminal:
Prime Line Pickup to the Primary Extension
¥
Ringing Line Preference
¥
To change the Auto Talk mode:
1. Hold down Trf key while
to On.
2. When mode changes a confirmation tone is generated:
Auto Talk Off: 3 Beeps
Auto Talk On: 2 Beeps
Answering calls:
1. When the Handset is on the Base unit, only the Base unit rings
and the Large LED flashes as usual.
2. When in Standby mode, the handset and Base unit both ring and
the message waiting LED flashes rapidly in conjunction with the
Base unit Talk/Batt.low LED.
Note: When Ringer On/Off switch is in Off mode, the Handset does not ring, but the
message waiting LED flashes.
With Auto Talk off:
1. When the Handset is on the Base unit, lift it and press any key.
2. The Talk/Batt.low LED flashes then lights continuously to indicate
established communication path between the Handset and the
Base unit.
3. Talk to the caller. The Message waiting LED is Off.
4. When finished, press the Talk key or place Handset back in the
Base unit to disconnect the call.
changing the Ringer On/Off switch from Off
term
D ® Handset Cordless
Electra Elite