Tenant Service - NEC Electra Elite 48/192 Features And Specifications Manual

Tenant Service

FEATURE
DESCRIPTION
SYSTEM
AVAILABILITY
OPERATING
PROCEDURES
SERVICE
CONDITIONS
Features and Specifications Manual
Tenant Service subdivides the system into a maximum of 48 Tenants that have
outside line access.
Terminal Type:
Not applicable
Required Components:
None
None
Data Assignment:
Use Memory Block 1-1-22 (DID Digit Conversion Table) to direct
¥
incoming DID calls to a specific Tenant (System Software S4000 or
higher is required).
Use Memory Block 1-4-12 (Automated Attendant Message to Tenant
¥
Assignment) to assign Automated Attendant messages to tenants.
Use Memory Block 2-01 (Trunk to Tenant Assignment) to assign CO/
¥
PBX lines to tenants 00~47 (default: All CO/PBX lines and stations are
assigned to Tenant 00).
Use Memory Block 2-05 (Line Key Selection) to select TNAT (Tenant-
¥
Wide Mode) or TEL (Telephone Mode default) line key assignment.
Default is TEL.
Use Memory Block 2-06 (Line Key Selection for Tenant Mode) to assign
¥
functions to each CO/PBX line key on each telephone in a tenant.
Default is CO.
Use Memory Block 2-07 (System Speed Dial Display Assignment) to
¥
specify whether or not confirmation of the speed dial numbers and
messages is allowed for tenants. Default is Yes (LEDs On).
T-3
T - 5