NEC Electra Elite 48/192 Features And Specifications Manual page 233

Issue 6
D - 24
Rerecord Key
Use this key to erase a recorded conversation while recording is
in progress and restart a new recording.
Urgent Page Key
Use this key to change the Live Record assignment from dial out
to pager. (Message Notification to Pager Assignment cycles ON/
OFF when this key is pressed while recording.)
Address Key
Use this key to confirm Live Record, erase Live Record, change
the mailbox number where Live Record is stored, or add a
recorded prelude to a recorded conversation.
During each Live Record, a conference circuit is used.
¥
Live Record is not allowed when all Add-On Conference circuits are
¥
busy.
Additional internal parties cannot be added to a live record
¥
conversation during conferencing.
Only CO/PBX, Tie, and DID calls can be recorded using Live Record.
¥
Internal calls cannot be recorded using Live Record.
The Record key LED is on when all conference circuits or all Digital
¥
Voice Mail ports are busy.
Any station user can direct a live record message to another station
¥
user.
Any Multiline Terminal can change the Message Notification mode to
¥
Pager Notification mode by first directing a live record message to
another station and then pressing the Urgent Page key. The station
that is put into the Urgent Page mode must have a pager telephone
number assigned.
An is displayed in the far right corner of the lower LCD when a
¥
,
Multiline Terminal (with LCD) is in Pager Notification mode.
Live Record is not allowed on conference calls.
¥
Centrex Transfer by Digital Voice Mail Port
System Software S5000 or higher is required.
Restrictions:
The CO used for Centrex transfer must be assigned as PBX in
¥
Memory Block 3-91 (Trunk Type Selection).
Electra Elite
Digital Voice Mail