NEC Electra Elite 48/192 Features And Specifications Manual page 533

Issue 6
SERVICE
CONDITIONS
S - 28
To use a Station Speed Dial Buffer using a Single Line
Telephone:
Multifunction (Dial Access) only:
1. Lift the handset, and wait for internal dial tone.
2. Dial the Station Speed Dial Access Code (default:
3. Dial the Station Speed Dial buffer number (
4. Talk with the called party.
Data Assignment:
¥ Use Memory Block 1-1-35 (Speed Dial Buffer Allocation) to specify
100 memories (default) allocation.
Restrictions:
¥ One-Touch keys programmed as Station Speed Dial cannot have a
name stored with the number to dial.
¥ A maximum of 13 characters can be entered for the name.
A maximum of 16 digits can be programmed for a One-Touch key.
¥
General:
¥ A maximum of 24 digits can be programmed for a Speed Dial buffer.
¥ A maximum of 16 Feature Access keys per station can be
programmed on unused line keys using System Software S5000 or
higher. A maximum of 16 digits can be programmed in each Feature
Access key.
¥ A pause, , and # may be programmed in a Multiline Terminal Station
,
Speed Dial buffer. Each item is counted as a digit; however, the Trunk
and Trunk Group Access Code do not count as digits.
¥ A pause and hookflash can be programmed in a Single Line
Telephone Station Speed Dial buffer, but only when using the Electra
Elite System Program Technician Software.
¥ Pauses stored in systems with the Least Cost Routing (LCR) feature.
may cause the MIFM-U10 ETU with KMM(1.0)U to seize a Least
Cost Route because the pauses may be considered digits dialed. In
systems using LCR, pauses should be programmed as part of extra
codes in the Extra Code Add Table.
Electra Elite
G G
) .
H K I I
~
) .
Speed Dial - Station