Direct Inward Dialing (Did - NEC Electra Elite 48/192 Features And Specifications Manual

Direct Inward Dialing (DID)

FEATURE
DESCRIPTION
SYSTEM
AVAILABILITY
OPERATING
PROCEDURES
SERVICE
CONDITIONS
Features and Specifications Manual
Direct Inward Dialing (DID) lines can be connected to the system. With DID,
incoming calls from the CO can reach any station in the system without
Attendant intervention.
System Software S4000 or higher allows sending DID calls to a tenant.
System Software S5000 or higher allows DID calls to be answered by the
Automated Attendant.
System Software S5000 or higher allows limiting the number of incoming
DID calls to a tenant.
Terminal Type:
All Multiline Terminals
Required Components:
DID(4)-U10 ETU, PRT(1)-U10/20 ETU, or DTI-U10/20 ETU
None
Data Assignment:
Incoming DID numbers can be routed to any station in the system
¥
regardless of the numbering plan. When an incoming DID number is
invalid, the call can be sent to a preassigned station or hunt group pilot
number.
Use Memory Block 5-00 (Digit Add/Del for Tie Line Networking
¥
Assignment) to add and/or delete a maximum of two digits per trunk
group, from the incoming DID digits provided by the DID trunk for
incoming address signaling. Setting 0 allows DID Full Digit Modification
that collects the incoming digits and sends the call to a specified station
number.
D-9
D - 27