Chapter 3 Ipk Iad(8)-U( ) Programming; System Programming - NEC Electra Elite IPK Installation And Maintenance Manual

C h a p t e r 3
___________________________________________________________________________________
S 1 S
ECTION YSTEM
The IAD (8)-U( ) ETU (Megaco Station) is recognized by the Electra Elite IPK system
as an ESI(8)-U( ) ETU. This ETU takes longer to initialize than the other Electra Elite
IPK ETUs and must be programmed using Memory Block 7-1 (Card Interface Slot
Assignment).
The following procedure provides the general directions for Electra Elite IPK
programming for the ETU Interface Slot Assignment.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
___________________________________________________________________________________
Hardware, Installation and Maintenance Manual
IPK IAD(8)-U( ) Programming
P
ROGRAMMING
From port 01 or 02, enter the programming mode.
A H
Press , ,
Assign the Card Interface Slot Assignment by pressing LK7 and LK1.
A B C
Press , or
ETU is installed.
L
Press to move the cursor to the right.
Enter slot number (1~8) of the KSU containing the IAD(8)-U( ) ETU.
C
Press to change the page number (Page 2).
Assign the ESI ETU and select LK1.
G
Press to write the data.
If assigning the telephone type and station number:
Assign the telephone type by pressing LK7 and LK2. (If assigning the Megaco
H
terminal, assign the port as: TEL = LK2.)
Assign a station number on a per port basis. (Elite KSU Programming MB 4-10)
H
 PC Programming can also be used to program the Electra Elite IPK system.
When programming the key telephone system, the IAD(8)-U( ) ETU (Megaco
Station) is always assigned as an ESI(8)-U( ) ETU.
L K J
, a nd .
for the cabinet number of KSU where the IAD(8)-U( )
3 - 1