Dp To Dtmf Switching - NEC Electra Elite 48/192 Features And Specifications Manual

DP to DTMF Switching

FEATURE
DESCRIPTION
SYSTEM
AVAILABILITY
OPERATING
PROCEDURES
SERVICE
CONDITIONS
Features and Specifications Manual
DP to DTMF Switching is required for systems connected to Dial Pulse (DP)
Tie lines that communicate with computers that require DTMF signaling.
Terminal Type:
All Multiline Terminals
Required Components:
TLI(2)-U10 ETU or DTI-U10/20 ETU assigned to support Tie lines.
To switch an outside call in progress on the Dial Pulse line:
J
1. Dial and
2. Dial desired number.
Data Assignment:
Use Memory Block 7-1 (Card Interface Slot Assignment) to specify the
¥
TLI(2)-U10 ETU or DTI-U10/20 ETU.
Restrictions:
This operation can be performed only on Tie lines.
¥
Dial Pulse Single Line Telephones cannot send DTMF signals, and
¥
cannot be used with this feature.
General:
After a DP line is switched to DTMF (by using an Access Code), the
¥
connection can only be switched back to DP by going on-hook.
DP/DTMF switching operations can be programmed as part of the
¥
Speed Dial program.
L
.
D-18
D - 53