NEC Electra Elite 48/192 Features And Specifications Manual page 158

Electra Elite
SERVICE
CONDITIONS
Features and Specifications Manual
.
To cancel Call Forward - All Split for Centrex from destination for
CAR key:
1. Lift the handset or press
2. Dial the Call Forward - All Split Cancel Access Code (Default not
assigned).
B
3. Press f or Centrex
4. Dial the CAR key extension number.
5. Go on-hook or press
Data Assignment:
Use Memory Block 1-1-46~48 [Access Code (1-, 2-, or 3--Digit)
¥
Assignment] to assign Access Code for Call Forward - Split.
Use Memory Block 1-8-07 [Class of Service (Attendant) Feature
¥
Selection 1] Page 2 LK 2 to Allow (default: LED On) or Deny (LED
Off) Call Forward Set/Cancel from destination.
Use Memory Block 1-8-07 [Class of Service (Attendant) Feature
¥
Selection 1] Page 2 LK 3 to Allow (default: LED On) or Deny (LED
Off) System-wide reset of Call Forwarding.
Use Memory Block 3-91 (Trunk Type selection) to assign lines as
¥
PBX (or CTX) or CTX (Assume 9).
Restrictions:
Memory Block 3-91 must have at least one trunk assigned as PBX
¥
(or CTX) or CTX (Assume 9).
assigned as PBX/CTX, the CTX/PBX=2 option is not displayed.
Call Forward - Centrex is not supported for Call Forward - All Call by
¥
the Feature + 60 operation from destination.
Call Forward - Centrex is not supported for Single On/Off toggle key
¥
operation.
A maximum of 16 digits can be stored as the destination outside
¥
number.
Least Cost Routing cannot route the Call Forward destination
¥
number.
When a Multiline Terminal with Call Forward - Centrex set has an
¥
unplugged extension, the call is not forwarded.
P
.
.
P
.
When at least one trunk is not
Issue 6
C - 39