Redundancy Page - Comtech EF Data CDM-625A Installation And Operation Manual

CDM-625A Advanced Satellite Modem
Ethernet-based Remote Product Management
7.5.4.6

Redundancy page

Take note of the following redundant switch information, as it pertains to IP
Packet Processor Redundancy:
Refer to the pertinent switch Installation and Operation Manuals for detailed
information on using the CDM-625A in a redundancy configuration.
Redundancy Config
•
Redundancy Traffic IP Address – Enter the IP Address and subnet mask in the form
XXX.XXX.XXX.XXX/YY.
• 1:1 Redundancy is supported using either a CRS-170A L-Band 1:1
Redundancy Switch or a CRS-180 70/140 MHz 1:1 Redundancy Switch, and
a user-provided, off-the-shelf Ethernet switch.
•
1:N Redundancy is supported using a CRS-300 1:10 Redundancy Switch or a
CRS-500 M:N Redundancy System in 1:N mode based on the following
criteria:
Redundancy Device
CRS-300
CRS-500
• Packet Processor Redundancy is supported in both 1:1 and 1:N redundant
configurations using the CRS-500 M:N Redundancy System.
Figure 7-48. Redundancy page
Packet Processor Terrestrial Interface
Disabled
EIA-422/530, V.35,
Disabled
Enabled
7–78
Revision 0
MN-CDM625A
Mode
Any Any
Any
Sync EIA-232
Ethernet L3 or Bridge