Config: Tx  Power; Config: Tx  Power  Mode  Aupc - Comtech EF Data CDM-625A Installation And Operation Manual

CDM-625A Advanced Satellite Modem
Front Panel Operation
Press ENTER when done.
CONFIG: Tx  Power  Mode  AUPC  Alarm-Action
Max Tx Pwr Action= None
Rem Demod Unlock Act= Nom-Pwr (Nom,Max)
On the top line
power level to be reached, use the
On the bottom line
arrow keys to select Nom-Pwr or Max-Pwr. Note the following:
the
▲▼
Selection
Nom-Pwr (Nominal Power)
Max-Pwr (Maximum Power)
Press ENTER when done.
When in IP-ACM Mode:
CONFIG: Tx  Power  Mode  AUPC  Mode/range
AUPC-ACM Mode = Normal (Normal, +/- Track)
Max Permitted Power Increase:3.0 dB ()
In all case except MEO (which is a very unusual mode) the mode is fixed at Normal. On the
bottom line, use the
between 0.0 and 9.9 dB.
CONFIG: Tx  Power  Mode  AUPC  Alarm-Action (IP-ACM
Mode)
Tx-Alarm: Max Power (MaxPwr,MinMCod,None)
Rem Demod Unlock Act=NomPwr(Nom,Max,Hold)
On the top line
power level to be reached, use the
can chose to generate an alarm when the maximum power or minimum ModCod has been
reached, or not at all.
On the bottom line
the arrow keys to select Nom, Max, or Hold. Note the following:
▲▼
To determine the action that occurs if the AUPC causes the maximum output
–
▲▼
To determine the action that occurs if the remote demod is unlocked, use
–
Function
The output level reverts to the nominal power level set under Manual.
The output level changes to the maximum permitted.
arrow keys to select the maximum permitted power increase,
▲▼
To determine the action that occurs if the AUPC causes the maximum output
–
▲▼
To determine the action that occurs if the remote demod is unlocked, use
–
(None, Tx-Alm)
arrow keys to select None or Tx Alarm.
arrow keys to select MaxPwr, MinMCod, None). You
6–16
Revision 0
MN-CDM625A