Comtech EF Data CDM-625A Installation And Operation Manual page 313

CDM-625A Advanced Satellite Modem
Serial-based Remote Product Management
Command
Parameter Number of
(Instruction
Type Arguments
& Qualifier)
Retrieve next 5 N/A 80 bytes
unread Stored
Events
Clear All CAE= None
Stored Events
Initialize Stored IEP= None
Events Pointer
Statistics SSI= 1 byte, numerical
Sample Interval
Description of Arguments
Query only.
Unit returns the oldest 5 Stored Events which have not yet been read over the remote control in the reply format
[CR]sub-body[CR]sub-body[CR]sub-body[CR]sub-body[CR]sub-body, where:
sub-body=ABCddmmyyhhmmss, where:
A is the fault/clear indicator:
F=Fault
C=Clear
I=Info
B is the fault type where:
1=Unit
2=Rx Traffic
3=Tx Traffic
4=Info (Power on/off, or log cleared)
5=Open Network
6=BUC
7=LNB
C is Fault Code number, as in FLT? or Info Code, which may be:
0=Power Off
1=Power On
2=Log Cleared
3=Global Config Change
4=Redundancy Config Change
5=Fractional CnC License is expiring.
6=Time Limited CnC License is expiring.
7=Fractional CnC is in use.
ddmmyy = date stamp.
hhmmss = time stamp.
If there are less than 5 events to be retrieved, the remaining positions are padded with zeros. If there are no new events,
the response is RNE*.
Command only.
Forces the software to clear the software events log.
Note: This command takes no arguments
Example: CAE=
Command only.
Resets internal pointer to allow RNE? queries to start at the beginning of the stored events log.
Command or Query.
Used to set the sample interval for the Statistics Logging Function in the form x, where:
x= 0 to 9 in 10 minute steps.
Note: Setting this parameter to 0 disables the statistics logging function.
Example: SSI=3 means 30 minutes
8–31
Revision 0
MN-CDM625A
Query
Response to
(Instruction & Response to Query
Command
Qualifier)
N/A RNE? RNE=[CR]ABCddmm
yyhhmmss[CR]ABCdd
mmyyhhmmss[CR]AB
Cddmmyyhhmmss[CR
]ABCddmmyyhhmmss
[CR]ABCddmmyyhhm
mss
(see Description of
Arguments)
CAE= N/A N/A
CAE?
CAE*
CAE#
IEP= N/A N/A
IEP#
SSI= SSI? SSI=x
SSI? (see Description of
SSI* Arguments)
SSI#