651
8.4
Description
Selection
Default
Programming
8-44
DECT Portable Station Section
DECT PS System Programming
PS Termination
Deletes a stored PS so that it cannot be used in the system.
• PS registration number: KX-TD816 – 01 through 16
Not applicable.
1.
Enter 651.
Display: PS Termination
2.
Press NEXT.
Display: PS NO?→
3.
Enter the PS registration number.
You can also keep pressing NEXT until the desired PS registration
number is displayed.
Display example: PS01:EXT 281
4.
Press STORE.
Display: Executing
The system searches for the PS registration number while "Executing"
is blinking, and deletes the registration after it is found.
Display example: Deleted
5.
To delete another PS, press NEXT or PREV, or SELECT
and the desired PS registration number.
6.
Repeat steps 3 through 5.
7.
Press END.
Even if "Rejected" is displayed in step 4 above, you can delete
the PS. In this case, Registration Clear on the PS (PS
Programming) is required.
Display: Rejected
The display changes after few seconds as follows.
Display: Delete?
5.
If you do not want to delete the PS, go to step 7.
KX-TD1232 – 01 through 64
(The PS is not registered correctly.)