Panasonic KX-TD816E Installation Manual page 535

8.2.4 Installing the Unit
8. Tie all of the cords into a bundle. If
other cords are exposed in the upper
cabinet, tie them also.
9. Close the cabinet cover and secure the
outside screw.
10. Cover the cords with the cord holder
(included).
11. Fix the cords to the wall as shown so
that the front cover can be opened.
Cord holder
Note If two expansion units are installed, cut
the cabinet cover(s) on the lower cabi-
net(s) to allow the cords from the upper
cabinet to go down through the cabinet
cover(s). To protect the cords, smooth
any cut edges.
SAFETY CAUTION
The small cover which provides access to
connectors CN402, CN403, CN404 and
CN405 shall not have its cable knock-out
section removed, unless another expansion
unit is mounted above which would prevent
finger access via the cable knock-out open-
ing. This safety requirement is necessary to
prevent user access to network voltages.
DECT Portable Station Section
Cut here
8-15