Using Reset Button - Panasonic KX-TD816E Installation Manual

6.1 Troubleshooting
PROBLEM
• During system
connection* operation,
originating an intercom/
outside call from a system
to the other system is not
possible.
• The indication "System
Link Down" is displayed
on the proprietary
telephone of Operator 1.
Originating an outside call,
Call Transfer, or Conference
cannot be performed.
6.1.4

Using Reset Button

*: Available for KX-TD1232 only.
PROBABLE CAUSE
Interface between the
systems is disconnected.
The corresponding CO
button does not exist on the
proprietary telephone.
If the system does not operate properly, use the Reset Button.
(If Master and Slave Systems are in operation by System
Connection, reset both systems.)
Before using the Reset Button, try the system feature again to
confirm whether there definitely is a problem or not.
Notes:
(a) When the System Clear Switch is set to "NORMAL," pressing
the Reset Button causes the following:
1. Camp-on is cleared.
2. Calls on Hold are terminated.
3. Calls on Exclusive Hold are terminated.
4. Calls in progress are terminated.
5. Call Park is cleared.
Other data stored in memory except the above are not cleared.
(b) When the System Clear Switch is set to the "CLEAR" position,
you must press the Reset Button with caution, because all data
stored in memory will be cleared by the following operation:
pressing the Reset Button and setting the System Clear Switch
to the " NORMAL" position while the Power Indicator is
flashing.
POSSIBLE SOLUTION
Connect the interface between the
systems and press the Reset Button
on both systems.
Program the CO button. See
Section 4.2 [005] "Flexible CO
Button Assignment."
Troubleshooting Troubleshooting 6-5 6-5